Create Holes by Fan Pattern

With a drill placed in your drill and blast project section, create multiple holes with a fan pattern.

Activity Steps

Note: A minimum of one section needs to be created in your drill and blast design project.

1. On the Drill and Blast tab, in the Design group, in Hole Layout drop down, select Fan Pattern.

2. Choose to Show your Drill on the drill line. Selecting Yes shows the drill sketch while creating your hole.

3. Select a Set Up you wish to drill from.

4. Choose your 1st point of your fan pattern. This is the left extent.

5. Choose your 2nd point of your fan pattern. This is the right extent.

6. Choose Keep to finalize the pattern, or:

   1. Increase the toespacing.

   2. Decrease the toespacing.

   3. Enter a custom Toespace value.

   4. Enter a custom Length value.

   5. Keep all the holes Flush.