Maintain Drill Pattern Types
Access drill pattern maintenance:
- On the DataBlast Application Menu, select Site Maintenance.
The Site Maintenance screen displays.
- Select the Mine Site » Drill Pattern Types node.
The Drill Pattern Type Maintenance Ribbon Menu displays.
To create a drill pattern type:
- Click Add Drill Pattern Type.
- Enter the Name.
- Complete the following fields.
- Backfill Check Percentage—The percentage of holes to be included in the backfill sheet out of the holes that need backfilling. Set to 100% if all holes that could be backfilled are to be included in the backfill sheet. See Generate and Print a Backfill Sheet.
- Active—Whether the drill pattern type can be selected when creating a drill pattern.
- Report In-Spec Tolerance
- Upper Load Tolerance—When entering drill log data or dip data, holes that are short by more than this tolerance are highlighted in red. See Enter Drill Log Data and Enter Dip Data.
- Lower Load Tolerance—Used to determine whether a hole needs to be backfilled. When entering drill log data or dip data, holes that are long by more than this tolerance are highlighted in blue.
- Drill Log Entry Form—Select from the defined drill log entry templates. See Maintain Measurement Entry Templates.
- Dip Entry Form—Select from the defined dip entry templates.
- Backfill Entry Form—Select from the defined backfill entry templates.
- Click Save Changes.
To deactivate a drill pattern type:
Note: You cannot deactivate a drill pattern type that is in use.
- Uncheck Active for the drill pattern type.
The drill pattern type displays with strike-through text.
- Click Save Changes.
