Holes Ribbon Menu

Fill an area of the current coordinate system with a grid of holes. See Create a Grid of Holes.

Create rows of holes that follow lines on the current coordinate system. See Create a Line of Holes.

Create a grid of holes parallel to a polyline on the current coordinate system. See Create a Curved Grid of Holes.

Create a single hole that passes through two selected points. Only use this option if you can snap to points at appropriate relative levels (RL).

Create single holes at fixed positions on the pattern design surface. See Create Single Holes.

Move selected holes without changing their bearing or angle.

Realign selected holes.

Change the bearing or angle of selected holes.

Trim selected holes so that they do not intersect with other holes.

Offset the drill toe of selected holes in the Z direction of the current coordinate system.

Offset the charge toe of selected holes in the Z direction of the current coordinate system.

Lock the bearings of all holes in the pattern so that the bearing cannot be edited in the Properties Pane. Can be useful if moving holes that are angled to a face or other plane and you want to maintain that bearing.

Change the angle increment value of selected holes. Default: As set when creating or last updating the selected holes. Blank if selected holes have different angle increments.

Group the selected objects so that if you select one hole in the group, all holes in the group are selected. The grouping is saved; however, groups are not visible in the Viewport.