View Stockpile Activity

Security Note: Assuming you can view the stockpile, no specific security right is required for this activity.

Activity Steps

  1. Open the WAG Stockpile, FIFO Stockpile, LIFO Stockpile, 3D Stockpile or Waste Stockpile.
  2. Select the Activity tab.
  3. In the Criteria field group, select the Start Date and End Date for the data to display.
  4. Click Refresh (in the Criteria field group).

    The dates of the First Transaction and the Last Transaction display with the transactions for the specified date range.

  5. To filter the transaction details by contributor, complete the following fields.
    • Contributor Group—Select from the contributor groups defined on the Quality panel of the Solution Explorer.
    • Contributor Cut Off—Limit below which contributors are not assigned. Any contributors with a value lower than the cut-off value are consolidated and grouped under 'Others'. The default Contributor Cut Off value can be any number between 0.1 and 99.99%, but is typically between 1% and 5%.

    The summarised tonnage details display for the contributors that have contributed a particular quantity to the total balance (that is, those that have only contributed a minor amount are filtered out) for the specified date range.

    Hover the mouse pointer over the Contributor Content to display a tooltip with calculated information about the relevance of the contributor information. The tooltip displays two values:

    • The best-known result type; for example, AssumeSource.
    • The relevance of the contributor value to the total mass of the stockpile or transaction. For example, a relevance of 50% indicates that the contributor value is relevant to 50% of the stockpile or transaction mass.
  6. To display analyte quality for the transactions, check Show Analytes.

    A column displays for each analyte definition for which there is quality data.

    Note: For WAG stockpiles, there is a tooltip over the analyte quality Value with information about the relevance of the sampled quality to the total mass of the stockpile. See Weighted-average-grade (WAG) Stockpiles for information about analyte quality relevance.

  7. Select whether to Show Analyte Content. This setting only affects analytes with Show Content Basis enabled in the Analyte Definition Editor. All other analytes display no analyte content. Disabled if no analytes are configured to show content basis.
  8. To view the transactions on another basis, select the Weight Basis.
  9. To open the source stockpile of a transaction, right-click the transaction and select Open Source from the menu.
  10. To open the destination stockpile of a transaction, right-click the transaction and select Open Destination from the menu.
  11. For transactions made with a transaction editor (that is, not despatch loading or unloading transactions; packing or unpacking transactions; or tolling transactions), to edit the transaction, right-click the transaction and select Edit from the menu.

    The Transaction Editor displays the transaction.