View the Stockpile Summary for a Location

This activity is not applicable to discrete unit locations. Instead, View the Current State of a Discrete Unit Location.

Security Note: Assuming you can view the location, no specific security right is required for this activity.

Activity Steps

  1. Open the Mine Location, Stock Location, Waste Location, Rail Siding, Truck Location, Barge Terminal or Port Location.
  2. Click Save to save any unsaved changes on other screens if required.

    Important: You will need to use the Refresh icon for this activity, which will discard any unsaved changes.

  3. Select the Stockpiles tab.
  4. Select the Start Date and End Date for the data to display.
  5. Click Refresh.
  6. Select whether to Show Analytes. If checked, a column displays for each analyte that has quality data.
  7. If Show Analytes is checked, select whether to Show Analyte Content. If checked, a column displays for each analyte that has Show Content Basis checked in the Analyte Definition Editor. Disabled if no analytes are configured to show content basis.
  8. Select the Weight Basis from bases defined in the Basis Editor.
  9. To filter the stockpile summary by contributor, complete the following fields.
    • Contributor Group—Select from the contributor groups defined on the Quality panel of the Solution Explorer.
    • Contributor Cut Off—Limit below which contributors are not assigned. Any contributors with a value lower than the cut-off value are consolidated and grouped under 'Others'. The default Contributor Cut Off value can be any number between 0.1 and 99.99%, but is typically between 1% and 5%.

    The summarised tonnage details display for the contributors that have contributed a particular quantity to the total balance (that is, those that have only contributed a minor amount are filtered out) for the specified date range.