Texture Drape Settings Dialog

To access this dialog use one of the following:

In the Sheets control bar, active 3D window - Wireframes folder, right-click an object, select Texture Drape Settings.

A Datamine eLearning course is available that covers functions described in this topic. Contact your local Datamine office for more details.

The Texture Drape Settings dialog is used to configure the orientation and position of texture images draped over DTM surfaces (wireframes).

Field Details:

Position: use these options to define the texture image origin position.

These are world coordinates which corresponding to a known location which can be identified on the image; these coordinates are NOT XY pixel coordinates on the image.

X: define an X origin coordinate.

Y: define an Y origin coordinate.

Z: define an Z origin coordinate.

Orientation: use these options to define the image orientation.

Azimuth: define the image direction (0-180 degrees).

Dip: define the image dip (-90 to 90 degrees).

Roll: define the roll value (rotation about the Z axis).

Scale:

Keep Aspect Ratio: make the ratio of the length and width of the image stay the same.

Width: stretch or squash the width of the texture.

Height: stretch or squash the length of the texture.

Use Points: define the texture image position using points; displays the Image Registration dialog.

Apply: apply and preview the currently defined dialog settings without closing the dialog.

OK: apply and save the currently defined dialog settings, close the dialog.

Cancel: cancel the currently defined dialog settings, close the dialog.