assign-drillhole ("asd")

See this command in the command table.

To access this command:

Using the command line, enter "assign-lithology-assign".
Use the quick key combination "asd".
On the Find Command screen, highlight assign-drillhole and click Run.

Command Overview

This command (and more commonly, the associated quick key combination) is used to apply the currently active attribute of the Assign Lithology screen to selected drillhole data.

Command steps:

Set Default data selection settings to Drillholes. See Selecting 3D Data Interactively.
Load drillholes to be coded.
Run the assign-lithology command.

The Assign Lithology screen displays. See Assign Lithology.
Select a Drillhole Table.
Select a Lithology Field.
Select a Legend for display purposes.
Enable Select Mode.
Pick 3D drillhole data to be coded.

Selected drillhole data is highlighted.
Type "ala" to assign the active Lithology Field to the selected drillhole data.

Note: You can also click Assign on the Assign Lithology screen.