outline-batch-switch ("trs")

See this command in the command table.

To access this command:

Using the command line, enter "outline-batch-switch".
Use the quick key combination "trs".
Display the Find Command screen, locate outline-batch-switch and click Run.

Command Overview

Toggle whether outlines are generated automatically or after string selection.

Used in conjunction with the generate-outlines and similar commands, this command will alternate the following operating modes for outline generation:

All possible outlines for selected string data are generated automatically.
Interactive selection of outline areas are required after running an outline generation command.

An example of how this switch is used can be seen here.

Command steps

Check the status of the outline-storage-switch.
Run this command.
Run generate-outlines if required, selecting string(s).
If required, reset the above switches.