edit-hole-attribute

See this command in the command table.

To access this command:

Enter "edit-hole-attribute" into the Command toolbar and press <ENTER>

Command Overview

Edit the properties of a drillhole data column. This command is unusual in that the command name requires a field to be added as a suffix. For example, if you wish to edit the LITH attribute value of a loaded drillhole, the command required is "edit-hole-attribute-LITH".

Note: running this command without a field suffix will result in a message indicating the command is unrecognised.

Command Steps:

Load static drillhole data.
Launch the edit-hole attribute command with a field name as an extension, e.g. "edit-hole-attribute-ZONE".

Note: The specified field name must be present on the current drillhole object
Pick a point on the loaded drillhole object
Enter the new attribute value to be applied at the selected location.
Click OK.

The loaded drillhole object is updated to reflect the new attribute value assignment.