set-default-density

See this command in the command table.

To access this command:

  • Using the command line, enter "set-default-density"

  • Display the Find Command screen, locate set-default-density and click Run.

Command Overview

Set the rock or material 'default' density for the project.

This is used in the absence of a DENSITY field or where absent density values ('-') are encountered when evaluating block model or drillhole data.

This setting is not used by the command-line evaluation commands shown below:

  • evaluate-1-string
  • evaluate-2-strings
  • evaluate-all-strings
  • evaluate-all-strings-plane
  • evaluate-wireframe
  • evaluate-set-of-wireframes

For the above commands, a custom default density value is provided as part of the command.

Command steps:

  1. Run the command.

  2. Enter a Default Density for evaluation.

  3. Click OK.