wf-boundary-line-switch ("twvb")

See this command in the command table.

To access this command:

Using the command line, enter "wf-boundary-line-switch"
Use the quick key combination "twvb".
Display the Find Command screen, locate wf-boundary-line-switch and click Run.

Command Overview

Toggle the display of wireframe open edges on or off during wireframe verification.

This command alternates your system between the following states:

Allow open edges, or boundaries of a wireframe, to be displayed during wireframe-verify, and to be output as strings wf-convert-line-switch is active.
Don't check for or display open edges as string data.

Note: The wireframe-verify command generates the adjacency information for the wireframe. Each triangle has PID values PID1, PID2 and PID3. The adjacent triangle number for the edge from PID1 to PID2 is stored in TRE1ADJ. If there is no adjacent triangle, the adjacency value is zero.