wf-merge-line-switch ("twvm")

See this command in the command table.

To access this command:

• Using the command line, enter "wf-merge-line-switch"

• Use the quick key combination "twvm".

• Display the Find Command screen, locate wf-merge-line-switch and click Run.

Command Overview

Toggle the display of wireframe shared edges on or off during wireframe verification.

After wireframe data has been merged (or intersected) with the wireframe- merge command, the shared edges between the intersected surfaces are identified with an adjacency value of -1 (stored in the fields TRE1ADJ, TRE2ADJ, TRE3ADJ). Each surface component that is bounded by other intersecting surfaces is assigned a new surface number and can then be independently manipulated.

This toggle allows the shared edges, or merge lines to be displayed during the wireframe-verify, and to be output as strings if the wf- convert-line-switch toggle is on. The strings cannot be created without the display toggle set on.

Related topics and activities:

• wireframe-verify ("wvf")

• wf-boundary-line-switch ("twvb")

• wf-convert-line-switch ("twcl")
• wf-intersect-line-switch ("twvi")
• wf-merge-line-switch ("twvm")