assign-results

See this command in the command table.

To access this command:

• Using the command line, enter "assign-results" and press ENTER.

Command Overview

Assigns tonnages and grades to a selected perimeter.

Command steps:

1. Run the command.

2. Select a perimeter to represent the tonnage zone as prompted.

3. If no current results file is open you are asked to supply one.

4. Set tonnage and grade field values as requested.

   Note: The grade field names are the same as those open for the current block model.

   After selection, the tonnage zone is shown with outlined squares on the perimeter segments.

Note: The data entered is stored in the results file, at a TIMENO of 0, where it can subsequently be used as a resource for scheduling.