outline-batch-switch ("trs")

See this command in the command table.

To access this command:

• Using the command line, enter "outline-batch-switch".

• Use the quick key combination "trs".

• Display the Find Command screen, locate outline-batch-switch and click Run.

Command Overview

Toggle whether outlines are generated automatically or after string selection.

Used in conjunction with the generate-outlines and similar commands, this command will alternate the following operating modes for outline generation:

• All possible outlines for selected string data are generated automatically.
• Interactive selection of outline areas are required after running an outline generation command.

Command steps

1. Check the status of the outline-storage-switch.

2. Run this command.

3. Run generate-outlines if required, selecting string(s).

4. If required, reset the above switches.

Related topics and activities

• outl-deselect-outer ("dol")

• generate-outlines ("ou")

• generate-outlines-attrib

• generate-grids-in-outlines ("gio")

• outline-inside-switch-off

• outline-inside-switch-on

• outline-selection-switch ("tsin")

• outline-storage-switch ("tsif")

• outl-limit-switch ("uo")

• outl-plane-switch ("ftp")

• outl-select-outer ("ool")