select-string

See this command in the command table.

To access this command:

Home ribbon >> Select >> String.
Using the command line, enter "select-string".
On the Find Command screen, highlight select-string and click Run.

Command Overview

Select or deselect a string for further operations. Whilst this command mode is active, only string data (open or closed) can be selected in a 3D window.

This command selects a "preferred" string for certain subsequent actions. For example, the insert-points-mode command will only add points to a selected string. The string is selected with the cursor by pointing to it. Once a string has been selected in this way, then subsequent commands needing a selected string will use the one chosen without requesting selection. To cancel a selection, this command is also used, followed immediately by another command.

Strings can be added to the already selected string data by holding down <CTRL> during selection. Reselecting an already selected string will deselect it.
The mouse can either be clicked to select a single string, or clicked and dragged to define a selection box. Whether strings will be selected by the defined box depends upon whether strings are set to be selected if all inside the box, or partly inside the box. This is controlled from the Data Selection area on the Points and Strings tab of the Project Settings screen.

Note: Data will only be selected if the displayed 3D object overlay is enabled on the Overlay Selection screen.