set-snap-surface-switch ("sts")

See this command in the command table.

To access this command:

• Use the quick key combination "sts".

• Using the command line, enter "set-snap-surface-switch".

• On the Find Command screen, highlight set-snap-surface-switch and click Run.

Command Overview

Toggle snap mode to snap to object surfaces. Enable this snap mode will snap to the position on a wireframe triangle surface directly below the cursor, in the current view direction.

Command Steps

1. Run the command.

2. Run the required, relevant design commands which would make use of this snap mode e.g. new-string.

Tip: The snapping mode can be changed while in the middle of executing another command, such as defining a string. For example, the first point on a new string could be set at (4000,2000,6000) using a grid snapping mode, and then other points on the string defined by snapping to other objects by toggling a points snap mode during digitizing.

Related topics and activities

• set-snap-grid-parameters ("gs")

• set-snap-grid-switch ("stg")

• set-snap-lines-switch ("stl")

• set-snap-mode ("snm")

• set-snap-none-switch ("sn0")

• set-snap-surface-switch ("sts")