snap-to-mid-string-switch ("stms")

See this command in the command table.

To access this command:

Home ribbon >> Snap >> Snap >> Snap to Mid Point.
Digitize ribbon >> Snap >> Snap to Mid Point.
Use the quick key combination "stms".
Using the command line, enter "set-to-mid-string-switch".
On the Find Command screen, highlight set-to-mid-string-switch and click Run.

Command Overview

Snaps the currently active string to the mid-point of another selected string or drillhole segment.

This function is an extension of the snap-to-point-data-switch.

With both switches active, it is possible to snap to both the mid-points and the end points of strings and drillhole segments. If the snap-to-mid-string-switch is not active, only the end-points may be snapped to.

Command steps:

Run the command.
Draw or extend a string using the left mouse button then, to activate the mid-segment function, right-click close to the string or drillhole segment whose mid-point the current string should end at. The string segment closest to the right-click is located, and a line is drawn to the mid point of that segment.