Project Settings

To access this dialog:

This dialog is opened at the relevant properties tab as part of several application functions.
Enter show-project-settings into the command line and press <ENTER>
Setup | Settingsusing theSystem ribbon to open the dialog without a particular context.

The Project Settings dialog is used to configure system-wide properties for your application. The options contained within this dialog will differ depending on how you accessed the dialog:

If you accessed this dialog from the Project Wizard, you will only see a General tab.
If you accessed this dialog from the File menu, with an active project, you will see multiple tabs.

For all tabs, the following standard buttons exist (although some may not be available until certain conditions are met e.g. data is changed on the form to enable the Apply button):

Select this...	...to do this
OK	Apply the current settings and dismiss this dialog.
Cancel	Dismiss this dialog without making any changes.
Apply	Apply the current settings without dismissing the dialog.
Help	Get help on the dialog.

The following tabs may be available, depending on how the dialog was opened:

General: contains general project settings.

Data Display: settings to control how information is displayed.

Design: settings specific to the Design window.

Desurvey settings: determine how drillhole data is interpreted during the desurveying process.

Digital Terrain Models: options relating to how DTMs are managed.

Legends: control how automatic legends are created.

Mine Design: settings relating to mine geometry and design.

Points and Strings: determine how strings, string outlines and string data selection is performed.

Wireframing: general wireframe process options.

Wireframing Linking: control how strings are linked to form wireframe volumes

GeoTechnical Settings: configure the calculation of average planes from a series of points, as used in the generation of key planes from strings.

Auto Recover: configure auto-save settings.

Drillholes: choose how drillhole data is selected in a 3D window.