berm-inside-taper-distance

See this command in the command table.

To access this command:

Command Overview

Note: automated pit design is available in your product. This can be quicker than using manual road design commands.

Berm tapering will gradually reduce the width of the berm where the berm meets the road in an open pit design.

This command will specify the length of berm over which the width of the berm will be reduced on the inside of the road.

Command steps

Run the command.
You will be prompted for the distance over which the tapering will take place. The default value (-) will assume the distance to be equivalent to the length of the last road segment.
The specified taper distance will used the next time any road berm creation command is used.