berm-outside-taper-switch

See this command in the command table.

To access this command:

  • Using the command line, enter "berm-outside-taper-distance"

Command Overview

Toggles the use of tapering in berm creation on the outside of the road.

Berm tapering will gradually reduce the width of the berm where the berm meets the road in an open pit design.

Command steps

  1. Run Command.

  2. When using this command in combination with berm-outside-taper-distance and road-berm-offset-percentage, the length of berm over which the berm will be reduced and the amount of reduction can be specified.

Examples

Both berm-outside-taper-distance and berm-inside-taper-distance turned on:

Both berm-outside-taper-distance and berm-inside-taper-distance turned off:
 

Related topics and activities