generate-distance-contours

See this command in the command table.

To access this command:

• Report ribbon >> Contours >> Generate Contours >> Generate Distance Contours.

• Enter "generate-contours-from-holes-intercepts" into the Command Line.

Description

This command is used to model contours representing the distance from sample positions.

 A points file must be loaded to access this command. Attributes are not considered with this command.

The outputs from this command are (optionally) contours strings and an output grid model. You cannot generate an output surface with this command, as the resulting strings and grid model will be assigned a fixed elevation.

By default, the grid model will lie just below the output strings, to allow them both to be visualized easily, e.g.:

You can change these settings using the Generate Contours - Output Data page.

This command uses the Generate Contours dialog:

1. Define the scope of contouring; select input objects.
2. Define the extents of your contouring by setting a minimum/maximum X and Y of the data hull (with an optional margin) and the resolution of the output grid.
3. Choose if you want to output contour strings and/or a grid object (a block model)
4. Configure how contour strings are created; define the lowest and highest values (and interval) and at which elevation you wish your output data to be positioned.

For more information on this command, please refer to Distance Contours

	Related Topics
	Distance Contours generate-contours-from-holes-intercepts generate-contours-from-points Contours from Points - Introduction