link-to-line ("ll")

See this command in the command table.

To access this command:

Solids ribbon >> Create >> Link >> Link to Line
Using the command line, enter "link-to-line"
Use the quick key combination "ll".
Display the Find Command screen, locate link-to-line and click Run.

Command Overview

Create a wireframe link between a perimeter (closed string) and a string.

In the example below, this command is used to link the top string with the underlying perimeter; the remaining perimeters are linked using link-strings, while the bottom perimeter is closed using end-link:

note.gif (1017 bytes)

The final wireframe volume:

note.gif (1017 bytes)

To close a shape off at a line to form a wedge requires that both strings are closed. This command will duplicate all points on the line effectively closing it. This point duplication is carried out internally prior to linking.
An error is reported if both of the selected strings are either open or closed.
If the line is specified with the minimum number of points, then additional points can be generated in the link with the new point separation (dtm-new-point-separation) command to improve the triangle shape.

Command steps:

In the Current Objects toolbar, select or create a new current wireframe object.
Run the command.
Following the prompts in the Status Bar, select a point on the first string.
Select a point on the second string.