rename-ring-holes ("rnr")

See this command in the command table.

To access this command:

• Use the quick key combination "rnr".

• Using the command line, enter "rename-ring-holes" and press ENTER.

• Display the Find Command screen, locate rename-ring-holes and click Run.

Command Overview

Interactively rename blast holes.

Command steps:

1. Load and display ring data.

2. Select one ring hole.

3. Run the command.

4. If no drillholes are selected, you are prompted to choose one. If one drillhole is selected, enter a new Hole identifier (the existing value displays here).

   Note: If multiple holes were previously selected, select one with the selection group to rename.

5. Click OK.

   The drillhole ID changes to the one specified.

Related topics and activities:

• rename-drillhole ("rnd")