Configure Multivariate Simulation GT Curve Properties

Multivariate Grade Tonnage (GT) Curves can be configured using the options in the MVS GT Curves tab.

Activity Steps

1. Select the MVS GT Curves component from the Project Tree.
2. Select the MVS GT Curves tab in the Property Panel.
3. Configure the following options as required.
   • Assay - The assay type displayed on the GT Curves.
   • Cut-Off Creation field group:
     • Start – Start value for the Cut-Off Values Table.
     • End – End value for the Cut-Off Values Table.
     • Step – Steps between values in the Cut-Off Values Table.
     • Add – Fill in the Cut-Off Values Table.

       Note: Clicking Add inserts values at the bottom of the Cut-Off Values Table using the parameters set in the Cut-Off Settings field group. To replace the values, click Clear first.

   • Cut-Off Values field group:
     • Cut-Off Values Table
     • Sort – Sort cut-off values by ascending order and remove any duplicate values.
     • Clear – Clear all values from the Cut-Off Values Table.
     • Include Cut-Off Values – Include cut-off values in grade tonnage analysis.