Command and Processes Table - B

For more information on the terms 'Command', 'Process' and 'Macro Command', see Command Table Introduction.

Commands not supported by your product are listed here for contextual purposes only - detailed information about these commands is available from their respective product help files.

Note: if a command is included within your application, you can access more information using the associated link in the right-hand column.

Symbols used in this table:

	- A green tick indicates that the module is part of the core system licensing for the specified product - no additional module is required
X	- A red cross indicates the module is not part of the listed system and any commands held within it cannot be run (a separate product will be required)
�	- A blue diamond indicates the module is an optional extra for the specified system

Commands - B

Command Name	Studio RM	Studio OP	Studio EM	Studio UG	Studio Survey	Studio NPVS	Studio Mapper	Description	More Help
berm-inside-taper-distance	X		X	X			X	Reduces the width of the berm where the berm meets the road in an open pit design.
berm-inside-taper-switch	X		X	X			X	Toggles the use of tapering in berm creation on the inside of the road.
berm-outside-taper-distance	X		X	X			X	Gradually reduces the width of the berm where the berm meets the road.
berm-outside-taper-switch	X		X	X			X	Toggles the use of tapering in berm creation on the inside of the road.
berm-string-colour	X		X	X			X	Sets the color for berm strings in an open pit design.
berm-to-wf-switch	X		X	X			X	Toggles wireframe intersection when creating a berm.
blast-layout			X	X	X	X	X	Layout a blast pattern within a perimeter to create a new set of drillholes
blast-layout-between-wf			X	X	X	X	X	Layout a blast pattern between wireframe limits to create a new set of drillholes.
blast-layout-from-wf			X	X	X	X	X	Layout a blast from a surveyed wireframe surface.
blast-layout-interactive			X	X	X	X	X	Use a simple wizard to lay out a blast pattern.
blend-fam-faces-switch	X		X	X	X	X	X	Toggle on or off the use of mining faces when blending.
blend-mining-blocks	X		X	X	X	X	X	Blend selected blocks according to specified targets.
blend-proportion-switch	X		X	X	X	X	X	Toggle switch for blending based on proportional mining.
borehole-warning-report								Check proximity and intersections of drillholes with wireframe surfaces	Command Help
box-all-points-inside-switch								Control whether string is selected if all points lie within selection box.	Command Help
box-any-points-inside-switch								Control whether string is selected if any point lies within selection box.	Command Help
break-string								Breaks a string at a selected point	Command Help
break-string-with-string								Break a string where it is crossed by another selected control string.	Command Help
break-strings								Breaks a string where it is crossed by any other string.	Command Help
build-holes								Create a set of desurvey holes from loaded raw drillhole collar, survey and other data.	Command Help

Processes - B

Process Name	Studio RM	Studio OP	Studio EM	Studio UG	Studio Survey	Studio NPVS	Studio Mapper	Description	More Help
BACKTR		X	X		X	X	X	The process back-transforms data from a normal distribution.
BHCOUNT					X		X	This command counts the number of boreholes used to estimate each model cell.
BLKPER							X	Creates a set of perimeters around blocks in a model file.
BLKTRI							X	Converts block model(s) to wireframe surfaces(s).

For Macro commands, see here.