move-plane-forward ("mpf")

See this command in the command table.

To access this command:

If using a keyboard, press Page Up.
Enter "move-plane-forward" into the Command toolbar and press <ENTER>.
Use the quick key combination "mbf" whilst a 3D view is active

Command Overview

Move the current view plane forward in a direction orthogonal to the plane. The plane is moved forward or backward by the current section width (as shown on the 3D View ribbon >> Clip >> Width).

Note: This differs from the move-plane command, where a custom movement distance is specified during the command.

The orientation of the section plane is not altered.

Command Steps:

Run the command.
The currently active section plane will be shifted forwards by the currently specified section width.