evaluate-current-wireframe

See this command in the command table.

To access this command:

Using the command line, enter "evaluate-current-wireframe" and press ENTER.
Display the Find Command screen, locate evaluate-current-wireframe and click Run.

Command Overview

Evaluate the current wireframe, either using an enclosed volume or a volume above or below a DTM (optionally constrained to an elevation limit). Loaded wireframe data should be verified beforehand.

This command is the same as evaluate-wireframe other than the current wireframe object is used, regardless of prior wireframe data selection.

This command displays the Evaluate Wireframe screen followed by the Evaluation Results screen.

Command Automation

You can automate by passing this command and parameters into oDmApp.ParseCommand(), using any COM-aware scripting language.

Note: For more information on scripting in Studio NPVS+, please refer to your Scripting Tutorial (Help > Scripting Tutorial).

Example Parameter String (JS):

oDmApp.ParseCommand("evaluate-current-wireframe '10' 'yes'";

Where:

'10' is the strBlockID: a string value parsed as a numeric block identifier.
'yes' is the strAcceptResults: a string value parsed to a yes/no intent. (Parameter is not actually used so can be left as the example and ignored).

Parameters Table

Parameter	Description	Reqd?	Example Syntax
`strBlockID`	A string value parsed as a numeric block identifier.	Y	`'10'`
`strAcceptResults`	A string value parsed to a yes/no intent. (Parameter is not actually used so can be left as the example and ignored).	N	`'yes'`