|
|
Describing fields and properties |
Create Isoshells - Condition
To access this dialog:
-
In the Create Isoshellsdialog, select theCondition tab.
The Condition tab in the Create IsoShells dialog allows you to condition the input data before it is passed to the interpolator - only available for Continuous isoshells.
Field Details:
Top/Bottom Cut: allows you to impose upper and lower limits on the input sample.
Maximum value: select this check-box, and type a value in the accompanying box - any input values which are greater than the number you specify will be reset to this value.
Minimum value: select this check-box, and type a value in the accompanying box - any values which are less than the amount you specify will be ignored.
Transform:
allows data to be transformed to a different distribution after any
Top or Bottom cut is performed, and before interpolation onto a regular
grid.
|
The isolevel values you supply are also transformed internally - you do not need to consider the transform process when specifying isolevels. |
None: input data is not transformed.
Log transform: a conversion to the log (Logarithm) of the input data is performed.
Normal
transform: maps the input data to fit a normal distribution.
|
|
If the input sample distribution is approximately lognormal, then the normal and log transformations will usually reduce the effect of high sample values. |
Restore: after generating isoshells by clicking OK,
clicking Restore allows parameters,
which are automatically saved, to be restored.
OK: generates isoshells using the parameters which you have specified.
Cancel: closes the Create IsoShells dialog without saving any parameters.
 |
Related Topics |
|
|
Create
Isoshells Dialog - Input
Create Isoshells Dialog - Estimation Parameters Create Isoshells Dialog - Volume Create Isoshells Dialog - Output Isoshells Report Dialog |
