select-wireframe ("sw")

See this command in the command table.

To access this command:

Home ribbon >> Pick >> Wireframes.
Use the quick key combination "sw".
Using the command line, enter "select-wireframe".
On the Find Command screen, highlight select-wireframe and click Run.

Command Overview

Note: Don't confuse this command with select-wireframe-data-switch and similar commands. These set the selection mode for wireframe data, either to allow data to be selected or not. In comparison, select-wireframe is a command that activates string picking mode.

Activates wireframe picking mode. Once active, you can use the cursor to select wireframe data according to the current Project Settings. This command will activate wireframe picking regardless of any other settings.

Command steps:

Define your wireframe selection settings,
Run the command
Pick wireframe data with the cursor. Depending on your selection settings either the whole wireframe object is selected, one or more triangles, data adhering to a particular GROUP or SURFACE or ATTRIBUTE, or a specific filter expression.

Note: This command supports flexible wireframe selection.