set-adjustment-cut-off ("scu")

See this command in the command table.

To access this command:

Model ribbon >>Manipulate >> Adjust to Ore >> Set Cut-Off
Using the command line, enter "set-adjustment-cut-off"
Use the quick key combination "scu".
Display the Find Command dialog, locate set-adjustment-cut-off and click Run.

Command Overview

Set grade field and cut-off grade for adjusting a string to an ore boundary using a block model.

This command sets the cut-off to be used when adjusting a string to an ore outline using the adjust-string-in-ore command. The initial value for the grade field is blank and the cut-off value is absent (-). The default value is the last value that was entered.

The block model field used for adjustment is the field currently defined by the selected evaluation legend. If this is changed with the assign-fill-codes command it is likely that the cut-off will need to be changed as well. If the string adjustment is being done using filter definitions of ore then the cut-off value is irrelevant.

For more information on this command, see adjust-string-in-ore.

Command Steps:

Run the command.
In the Cutoff Grade screen, define the grade field and cut-off grade.
Click OK.