set-tolerance ("sto")

See this command in the command table.

To access this command:

Using the command line, enter "set-tolerance"
Use the quick key combination "sto".
Display the Find Command screen, locate set-tolerance and click Run.
Project Settings screen >> Wireframes >> Tolerance.

Command Overview

Set matching tolerance for points to be used in the generation of a Digital Terrain Model (DTM).

Note: For DTM formation no triangles is created with sides of length less than this tolerance.

Note: For the wireframe-verify command points within this tolerance are considered duplicate for the purposes of verification. Any triangles that are degenerate after this point merging are discarded.