toggle-drillhole-selection ("tds")

See this command in the command table.

To access this command:

  • Display the Project Settings screen, activate the Drillholes panel and choose a selection mode.

  • Using the command line, enter "toggle-drillhole-selection".

  • Use the quick key combination "tds".

Command Overview

Toggles between full drillhole and individual sample selection when picking data in a 3D window. You can either select an entire drillhole when picking, or a distinct drillhole interval (this is set using the switch-drillhole-selection command or Project Settings >> Drillholes.

Note: This command is another way of accessing switch-drillhole-selection, retained for legacy purposes. Toggling this legacy command alternates between Select entire drillhole and Select drillhole samples options.

Command steps:

  1. Load and display at least one drillhole overlay in a 3D window.

  2. Run the toggle-drillhole-selection command to alternate between full drillhole and individual sample selection modes.

Related topics and activities