dynamic-evaluation-report

See this command in the command table.

To access this command:

• Report ribbon >> Evaluate Dynamic >> Strings.

• Reserves ribbon >> Evaluate Dynamic >> Strings.

• Using the command line, enter "dynamic-evaluation-report".

• Display the Find Command screen, locate dynamic-evaluation-reportand click Run.

Command Overview

Evaluate a set of perimeters using dynamic evaluation methods (either using block model or drillhole data for calculations).

Evaluation is performed by projecting the closed string(s) either in a vertical direction or orthogonally to the currently active section.

Command steps:

1. Run the command.

   The Evaluation 2D Strings Properties screen displays.

2. Define object and evaluation settings.
3. Click OK.

4. Review the results displayed on the Table View screen.

   Note: If absent grade values are found, then they are replaced by the average value for the grade, and a message is displayed in the Notes section.

5. Click Save Results.

   The Save Evaluation Results displays.

6. Define data save settings, and click OK.

Related topics and activities

• Evaluation 2D Strings Properties

• Table View

• Save Evaluation Results

• evaluate-1-string ("ev1")

• evaluate-2-strings ("ev2")

• evaluate-all-strings ("eva")

• evaluate-all-strings-plane

• evaluate-current-wireframe

• evaluate-set-of-wireframes

• evaluate-wireframe ("evw")