use-rosettes-switch ("tur")

See this command in the command table.

To access this command:

Using the command line, enter "use-rosettes-switch" and press ENTER.
Use the quick key combination "tur".
Display the Find Command screen, locate use-rosettes-switch and click Run.
Design ribbon >> Slope >> Use Rosettes.

Command Overview

Note: A rosettes file must be loaded before this command can be run.

Toggle the use of rosettes in string projection or offsetting.

If this switch is active, the face projection angle for string projection, or the expansion distance for offsetting, is derived from the loaded rosettes file points and their parameters. The detected values will take preference over the default face angle and expansion distance but have a lower priority than the loaded block model SLOPE field.

This toggle is generally used when running open pit design commands but can also be used with more general string offsetting commands.