Supervisor Settings

The Supervisor Settings menu in the Options Tab has two subsections. Selecting one of the subsections opens the Options tab in the Property Panel, with settings specific to the selected subsection. Each subsection has the following settings in the Options tab.

  1. General Options
    • Distance units – Enter the units used to measure distance in your analyses.
  2. Variogram Options
    • Down-hole granularity
    • Detach source data on creation of Fan – See Link to the Data Source for morne information.
    • Separation section
      • Max default separation
      • Half spatial separation
      • Warn when separation cut
    • Autofit section
      • Range limit factor
      • Warn when range limited
    • Model Colouring Section
      • Use only when overlaid
      • Down-hole
      • Direction 1
      • Direction 2
      • Direction 3