Set or Change the Charge Standard for a Charge Pattern

Activity Steps

1. Select the Charge module.
2. Select a charge pattern in the DataBlast Items Tree.

   The pattern displays in the Viewport.

3. Select holes or the entire pattern. See Select Objects in the Viewport.

   Note: The charge standard is set for the entire pattern, even if you only select some holes. If you need to set a charge standard for a subset of holes, either modify the charge standard for individual holes, or Extract Holes to a New Charge Pattern.

4. On the Charge ribbon menu, in the Charge Apply group, click Set Charge Standard.

   The Charge Standard Selection screen displays the defined Charge Standards for the hole diameter and of the applicable charge standard type.

5. Select the Initiation System Type from Non-Electric and Electronic.
6. Select the required charge standard.
7. Click Select.
8. If any holes in the charge pattern have been used in an initiation pattern, a confirmation message displays. Click OK.

   The changes are saved automatically.