clip-to-perimeter ("ctp")

See this command in the command table.

To access this command:

Edit ribbon >> Tools >> Clip.
Surfaces ribbon >> Tools >> Clip to Perimeter.
Using the command line, enter "clip-to-perimeter".
Use the quick key combination "ctp".
Display the Find Command screen, locate clip-to-perimeter and click Run.

Command Overview

Deletes all string and point data from either inside or outside of a perimeter.

Note: If string or point data is loaded but not displayed, it is not affected by this command.

Command steps:

Ensure data to be clipped, and the clipping perimeter, is visible in a 3D window.
Run the command.
Select the clipping perimeter.
Select a point either inside or outside of the perimeter to choose which data is deleted.

Strings and points are clipped to the edge of the perimeter.