fillet-single-string-point

See this command in the command table.

To access this command:

Edit ribbon >> Condition >> Condition >> Fillet Single String Point.
Surfaces ribbon >> Condition >> Condition >> Fillet Single String Point.
Using the command line, enter "fillet-single-string-point"
Display the Find Command screen, locate fillet-single-string-point and click Run.

Command Overview

Specify the maximum curvature radius permitted between line segments on points of a string. Points will be added to the line where appropriate to maintain the maximum radial curvature. This command is used to modify selected point(s) on a line - to fillet all points on a selected line, use the fillet-string-points command.

Note: Your string data can be on any plane. Filleting is performed using the mean plane of the selected string.

Command steps

Ensure at least one string is loaded and in view in a 3D window.
Run the command.
Specify a Radius for Filleting.
Select a point on a line to modify.

The 'corner' created by the convergence of the line segments at that point is modified according to the radial curvature specified.