road-berm-offset-percentage

Command Name

Menu

Quick Key

Link to Command Table

road-berm-offset-percentage

Design ribbon | Roads | Berm Offset

-

Click here

Description

Berm tapering will gradually reduce the width of the berm where the berm meets the road in an open pit design.

When used in combination with the commands berm-outside-taper-switch and berm-inside-taper-switch, this command will reduce the width of the berm where it meets the road by the supplied percentage.

How to Use

  1. This command can be used by typing it in the “run-command” select box.

  2. You will be prompted for the percentage of the width of the berm at the place where the berm meets the road. The default value (100%) will reduce the width of the berm to null. Supplying a value of 0% will not reduce the width of the berm.

Examples:

Offset = 100%:

Offset = 50%: