Command and Processes Table - B

For more information on the terms 'Command', 'Process' and 'Macro Command', see Command Table Introduction.

These tables list all commands and processes available in all products. If your product has access to a command or process, the link on the left of the table takes you to a dedicated help file for more information. If no link appears, the function isn't available in your product.

Symbols used in this table:

A green tick indicates that the module is part of the core system licensing for the specified product - no additional module is required.

X A red cross indicates the module is not part of the listed system and any commands held within it cannot be run (a separate product will be required).

� A blue diamond indicates the module is an optional extra for the specified system.

For Macro commands, see here.

Commands - B

Command Name								Description	More Help
berm-inside-taper-distance	X	X	X	X			X	Reduces the width of the berm where the berm meets the road in an open pit design.	Command Help
berm-inside-taper-switch	X	X	X	X			X	Toggles the use of tapering in berm creation on the inside of the road.	Command Help
berm-outside-taper-distance	X	X	X	X			X	Gradually reduces the width of the berm where the berm meets the road.	Command Help
berm-outside-taper-switch	X	X	X	X			X	Toggles the use of tapering in berm creation on the inside of the road.	Command Help
berm-string-colour	X	X	X	X			X	Sets the colour for berm strings in an open pit design.	Command Help
berm-to-wf-switch	X	X	X	X			X	Toggles wireframe intersection when creating a berm.	Command Help
blast-layout			X	X	X	X	X	Layout a blast pattern within a perimeter to create a new set of drillholes
blast-layout-between-wf			X	X	X	X	X	Layout a blast pattern between wireframe limits to create a new set of drillholes.
blast-layout-from-wf			X	X	X	X	X	Layout a blast from a surveyed wireframe surface.
blast-layout-interactive			X	X	X	X	X	Use a simple wizard to lay out a blast pattern.
blend-fam-faces-switch	X	X	X	X	X	X	X	Toggle on or off the use of mining faces when blending.
blend-mining-blocks	X	X	X	X	X	X	X	Blend selected blocks according to specified targets.
blend-proportion-switch	X	X	X	X	X	X	X	Toggle switch for blending based on proportional mining.
borehole-warning-report								Check proximity and intersections of drillholes with wireframe surfaces	Command Help
box-all-points-inside-switch								Control whether string is selected if all points lie within selection box.	Command Help
box-any-points-inside-switch								Control whether string is selected if any point lies within selection box.	Command Help
break-string								Breaks a string at a selected point	Command Help
break-string-with-string								Break a string where it is crossed by another selected control string.	Command Help
break-strings								Breaks a string where it is crossed by any other string.	Command Help
build-holes								Create a set of desurvey holes from loaded raw drillhole collar, survey and other data.	Command Help

Processes - B

Process Name							Description	More Help
BACKTR	X	X	X	X	X	X	The process back-transforms data from a normal distribution.
BHCOUNT				X		X	This command counts the number of boreholes used to estimate each model cell.
BLKPER						X	Creates a set of perimeters around blocks in a model file.	Process Help
BLKTRI						X	Converts block model(s) to wireframe surfaces(s).	Process Help
BOOLEAN						X	Access Boolean wireframing functions.	Process Help