berm-outside-taper-distance

See this command in the command table.

To access this command:

  • Design ribbon >> Berm Taper >> Distance >> Outside

  • Using the command line, enter "berm-outside-taper-distance"

Command Overview

Berm tapering will gradually reduce the width of the berm where the berm meets the road in an open pit design and is used in conjunction with berm-outside-taper-switch.

This command will specify the length of berm over which the width of the berm will be reduced on the outside of the road.

Command steps

  1. Run the command.

  2. You will be prompted for the distance over which the tapering will take place. The default value (-) will assume the distance to be equivalent to the length of the last road segment.

Related topics and activities