Dump Settings

To access this screen:

  • On the Scheduling Setup screen, select or add a dump destination type and enable the Model tab.

Use the Dump Settings screen to define dump modelling files output from the Dump Evaluation process.

These files specified on this screen are normally output from the Dump Evaluation process.

Activity steps:

  1. Display the Dump Settings screen.
  2. To set up and enable dump modeling, select Enable Dump Modeling.
  3. In Dump Definition, select a dump definition table.
  4. In Dump Wireframe, select a dump wireframe model object.
  5. In Dump Outlines, select a dump outlines (strings) object.
  6. In Swell Factor, enter a value (>= 1).
  7. In Haul Factor, enter a value (> 0).
  8. In Rolling Resistance (%), enter a value (%) (>= 0).
  9. In Maximum Speed (km/h), enter a value (km/h) (>= 1).
  10. In Road Tolerance (m), enter a value (m) (>= 0).
  11. To save the defined parameters to the selected dump destination, select Apply.
  12. To close the screen without saving the defined parameters, select Revert.

Related topics and activities